Primary E-Mail
scott@evdeals.com
Alternate E-mail
ghastly1@yahoo.com
snit33a@verizon.net
smacgregor@aasp.net
Call 508-695-3717
Fax 508-643-0233
ELECTRIC
POLITICS
EVdeals Policies
Battery Tests
Dynamometer Tests
FAQs
Tech
Tips
Performance
Testing
Pictures of Custom Projects
Plans & Projects
Instructions
Yard Sale
Bob the Blob in Safety
First
(brief you-tube video)
Join
the Yahoo electric scooter e-mail group FREE!
Click HERE
© 1999-2010 EVdeals.com
No part of this site may be reproduced or
transmitted in any form or by any means, electronic or mechanical,
including photo- copying, recording, or by any information storage and
retrieval system
without permission in writing from the publisher.
By appointment only!
Scott MacGregor
Plainville, MA 02762
Phone: (508) 695-3717
Fax: (508) 643-0233
Flyer SE Gear Upgrade
The EVdeals gear upgrade kit includes all the parts and instructions necessary to raise the top speed of the Flyer SE to nearly 20 mph! Riders lighter than 160 lbs are likely to achieve speeds in excess of 20 mph, while those on the heavier side will reach somewhat lower speeds.
Kit includes custom made .500" heat treated and "hard-turned" motor shaft adapter, bearing spacers, 19T pinion gear, pre-installed Sprague roller bearing clutch, chain parts, and installation instructions.
Installation does not require removal of the rear wheel and axle assembly!
Be sure to read the "Recommended Limits of Operation" section below before deciding to install this upgrade on your Flyer SE!
Complete kit with instructions $59.95
Dynamometer TEST Results
Back to Parts and Accessories
Recommended Limits of Operation: This gearing has been dynamometer and field tested, and provides approximately 3 MPH speed increase over stock gearing. However, the hill climbing ability and range of the Flyer will be somewhat reduced. Care should be taken to check motor temperature during early test runs with the new gearing! Avoid steep hills! (those over ~8% grade) Lighter riders may find this restriction unnecessary!
Be certain that tire pressure is at or near 40 PSI to avoid overloading the motor. Riders heavier than ~175 lbs should check for excessive motor temperature frequently, until more experience is gained.
Average Speed Duration
(min)
Range
Maximum Speed
EVdeals.com
508-695-3717
scott@EVdeals.com